Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Encino, CA
Chimney repair in Encino usually means one of two things: a cracked clay liner found during a routine sweep, or water getting in around a flashed, uncapped flue on a 1960s ranch. Ashwood Chimney Sweep has served Encino since 2012, and most of the repair work we do here follows the same pattern – an original masonry fireplace south of the Ventura Freeway that was never built with a modern liner, now adapted for gas logs and quietly deteriorating. We clean, inspect, and repair the whole flue in one call. If you need an assessment, call (833) 805-3229.
Why Encino Homes Are Different
Encino’s housing stock runs heavily to mid-century ranch and traditional two-story homes built between the 1950s and 1970s. Those houses, especially in the 91316 and 91436 ZIP codes, commonly have original brick or stone fireplaces with single wythe masonry chimneys. A single wythe is one layer of brick – no air gap, no second wall. That matters because it leaves little room for error when a liner cracks or water works its way in.
The climate does something specific here too. Encino sits in a bowl in the San Fernando Valley, and the warm, dry Mediterranean weather means fireplaces get lit maybe a dozen nights a year. Creosote buildup is minimal compared to colder markets. What we actually find is dust, soot, leaf debris from mature valley oaks, and the kind of slow water intrusion that happens when a cap is missing and a rare winter rain drives sideways against an exposed flue. In the hillside streets south of Ventura Boulevard, including the Amestoy Estates area, original 1960s fireplaces often share a chase with the furnace vent. That detail turns a standard cleaning into a repair conversation more often than homeowners expect.
Styles & brands we work with
Our Main Encino Services
The two services Encino homeowners call about most are chimney sweeping and dryer vent cleaning. Both are fire-safety work, and both run into the same local conditions: older flues, dry-season debris, and vent runs that haven’t been opened in years.
Chimney Sweep in Encino
A sweep in Encino is less about heavy creosote removal and more about a careful inspection of a rarely used, often gas-converted flue. We check the firebox, the damper, the liner, and the cap, then clean out the dust, soot, and leaf litter that builds up during the long dry season. Many calls start because a homeowner lit the first fire of the year and smelled something off. For the full scope of that service, see our Chimney Sweep in Encino page.
Dryer Vent Cleaning in Encino
Dryer vents in Encino collect the same fine dust and lint that settles everywhere else in the Valley, and a blocked vent turns a dryer into a fire risk. We treat this as a serious ventilation safety service, not an add-on. Runs are often long in these mid-century layouts, sometimes exiting through a roof. See our Dryer Vent Cleaning in Encino page for how we handle those.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Encino
Most chimney repair work in Encino starts with a discovery made during an inspection. A homeowner books a sweep, and we find a cracked clay tile in a flue that has never had a liner installed. Or water has been getting past a rusted chase top on a hillside home off Hayvenhurst Avenue, soaking mortar for years. The homes south of the Ventura Freeway, built in the 1950s and 1960s, predate modern liner requirements, and many original fireplaces now run gas logs without any flue protection at all. That is exactly the situation Chimney Repair work addresses – and we use HeatShield, DuraFlex, and Olympia Chimney materials because this is not a job for bargain parts.
Chimney Cap Installation
Signs you need it
Rain streaking down the fireplace wall, a wet smell from the firebox after winter storms, or birds and leaves getting in because the flue is wide open.
What it costs in Encino
Chimney cap installation in Encino typically runs $300 to $600 depending on the flue size and the cap type matched to the existing clay tile.
How we do it
We measure the flue opening, set a stainless or copper cap in place with mechanical fasteners, and seal the underside so wind-driven rain can’t sneak around the edges.
Chimney Cap Replacement
Signs you need it
Rust holes in the mesh, a cap that has blown off in Santa Ana winds, or an old galvanized lid that’s corroded through at the corners.
What it costs in Encino
Replacing a damaged cap in Encino is $350 to $650, including removal of the failed unit and installation of a properly sized replacement.
How we do it
We pull the old cap, check the flue tile for damage underneath, then install a new cap and verify the draw with a quick smoke test.
Chimney Liner Installation
Signs you need it
Cracked clay tiles visible from the top, an inspection camera showing gaps or spalling in the flue walls, or a fireplace that leaks smoke into upper rooms even with the damper open.
What it costs in Encino
A stainless liner install in Encino runs $2,500 to $5,000 depending on flue height and whether an insulation wrap is required for code compliance here.
How we do it
We size the proper DuraFlex liner, lower it down the existing flue, connect the appliance collar, and secure everything top and bottom with a new cap and plate.
Chimney Flashing Repair
Signs you need it
Water staining on the ceiling near the chimney, damp drywall in the chase, or rusted, lifted flashing visible where the flue passes through the roofline.
What it costs in Encino
Flashing repair in Encino is $450 to $900, with the price moving higher when roof tiles must be lifted and reset to reach the seal properly.
How we do it
We strip the old flashing, cut new step and counter-flashing to fit the chimney and roof pitch, then seal with a roofing-grade polyurethane that handles Valley heat without cracking.
What Chimney Repair Costs in Encino
| Item | Typical range in Encino |
|---|---|
| Chimney cap installation | $300 – $600 |
| Chimney cap replacement | $350 – $650 |
| Chimney flashing repair | $450 – $900 |
The largest variable in Encino is access. Two-story traditional homes on hillside lots off Valley Vista Boulevard usually need roof access with safety gear, and tile roofs add labor to any flashing or cap job.
Do I actually need a new liner, or can the old one be repaired?
Most cracked clay liners in Encino can be restored with HeatShield rather than replaced. The product resets the inner surface of the flue without demolition. Full liner replacement is only needed when the original clay is structurally collapsed or the flue is shared with a furnace vent and must be brought to current code.
How long does a chimney liner repair take in Encino?
HeatShield restoration is usually a one-day job because the material cures in stages through the day. A full DuraFlex liner install takes one to two days depending on flue height and access. We’ll give you a firm window when we quote. Call (833) 805-3229 for an exact price.
Brands We Service in Encino
We stock and install DuraFlex liners, Olympia Chimney caps and chase covers, and Famco ventilation components. Encino jobs are quoted with these trade-grade materials, and common cap sizes are kept on the truck so we can usually finish a cap replacement in a single visit. See our brands for the full lineup.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Encino, CA
| Service | Typical range in Encino |
|---|---|
| Chimney sweep and inspection | $169 – $249 |
| Dryer vent cleaning | $150 – $250 |
| Chimney cap installation | $300 – $600 |
| Chimney cap replacement | $350 – $650 |
| Chimney flashing repair | $450 – $900 |
| Chimney crown repair | $350 – $700 |
| HeatShield liner restoration | $1,500 – $3,500 |
| Stainless chimney liner installation | $2,500 – $5,000 |
Prices in Encino get pushed up by two things: roof access on two-story homes and the condition of the existing chase. Homes in the hills south of Ventura Boulevard often have steeper rooflines and older tile roofs that add labor. What doesn’t change: we quote a flat price before any work starts, and nobody pays for a repair we couldn’t show them on camera.
Neighborhoods We Serve in Encino
We work throughout Encino, from the streets north of the Ventura Freeway down into the hills and across the 91316, 91416, 91426, and 91436 ZIP codes. Our techs know the difference between a flat ranch off White Oak and a hillside house in Amestoy Estates, and we schedule accordingly.
- Amestoy Estates
- South of Ventura Boulevard (Langdon Ave, Hayvenhurst Ave corridors)
- Encino Commons and the 91426 blocks near Balboa Park
- North Encino near Ventura Blvd commercial district and the freeway
- Encino Village
Depending on the week, we typically reach Encino within two to three business days from your call. Spring and early fall are the busiest because homeowners book before the first burn of the season.
Service Area – Cities Near Encino
We handle chimney and vent work throughout the southwestern San Fernando Valley. From Encino we regularly run jobs into Sherman Oaks, CA along Ventura Boulevard, up to Van Nuys, CA and Valley Glen, CA, and west into Northridge, CA for the same mid-century ranch stock that defines Encino’s chimney profile.
Serving Encino, CA — Our Local Coverage Area
We’re based in the Encino area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Encino
We schedule Encino visits within two to three business days in most cases. Roof access on two-story homes doesn’t add days – it’s priced into the flat quote, not the calendar. If we’re already working nearby, we’ll often pull your job earlier.
Encino falls under the City of Los Angeles building code. A liner replacement or any structural repair to the chase usually requires a permit, and we handle that paperwork as part of the job. Simple cap replacement and flashing work below a certain scope usually do not.
Yes. If you’re booking a sweep, adding the dryer vent costs less than ordering it as a separate call because we’re already at the property with the equipment. Call (833) 805-3229 and we’ll quote both together.
If your fireplace hasn’t been inspected since you moved in, or you’ve been told you need liner work you can’t verify, call Ashwood Chimney Sweep at (833) 805-3229 for a free estimate. We’ve served Encino since 2012, and every repair we recommend comes with camera evidence you can see for yourself.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Encino Customers Say
"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
— Lina Aziz"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
— Alejandro Garcia"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
— Paul Padgett