Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Stanton
Dryer vent cleaning in Stanton typically runs $129 – $189 for a standard single-story tract home, and most jobs are done within 90 minutes. If your dryer takes two cycles to dry a load, the vent is almost certainly packed with lint. That’s the call we get most often from Stanton homeowners, and it’s the one we fix most often, too. Norm Castillo has been running our crews through these 1950s and 60s tracts for years, and we know exactly what’s behind those stucco walls off Beach Blvd and Western Ave. Call (833) 805-3229 and we’ll walk you through what we’re going to do before we even pull up.
Why Ashwood Chimney Sweep Is Stanton’s Preferred Dryer Vent Cleaning Company
We’re a full-service ventilation company, not a one-task crew. That matters in Stanton because most of these postwar tract homes share a wall chase between the dryer duct and the original masonry fireplace flue. A company that only does dryer vents misses what’s happening six inches away. We clean the duct, check the termination, and look at the flue cap and chase in the same visit. Homeowners along Beach Blvd, in the neighborhoods west of Western Ave, and throughout 90680 have told us the same thing: the previous guy never even looked at the chimney side. We always do.
Stanton customers see the difference in the report we leave behind. You get photos of your duct before and after, plus a note on any corrosion, crushed pipe, or cap failure we found. That’s standard for us, not an upsell. It’s the same discipline we bring to Dryer Vent Cleaning across our Southern California service area, and it’s why Stanton homeowners keep our number on the fridge.
Styles & brands we work with
Our Dryer Vent Cleaning Services in Stanton
Dryer Vent Cleaning and Lint Removal
We run rotary brushes and compressed air through the full duct run, from the dryer connection to the exterior termination. In Stanton’s 1950s – 60s tract homes, the duct path is usually short, straight, and buried in a wall chase alongside the fireplace flue. That layout traps lint fast, especially in rental units off Beach Blvd and Western Ave where the duct hasn’t been pulled in years. We clean it thoroughly and verify airflow with a draft check before we leave.
Stainless Steel Vent Hood and Cap Replacement
Salt air off the Pacific is rough on galvanised steel. The original vent hoods on Stanton tract homes were builder-grade galvalume, and after 60 years of coastal exposure, most have rusted through or seized shut. We replace them with stainless steel hoods and caps that resist the corrosion these neighborhoods throw at them. A stainless termination on the dryer vent and a matching cap on the adjacent fireplace flue is the fix we recommend most often in 90680.
Rigid-Pipe Dryer Duct Rerouting
Foil flex duct crushes behind builder-era vent hoods. When it crushes, lint packs at the pinch point and airflow drops to nothing. We pull the old flex, replace it with smooth rigid pipe, and reroute where needed so the duct runs clean and straight. On a small two-story stucco tract house near Beach Blvd and the 22 Freeway, we pulled a dryer duct that had crushed itself behind the original galvalume vent hood, packed solid with lint and one long-abandoned bird nest. The galvanised cap on the adjacent fireplace flue had rusted through from salt-air exposure, letting rain into a firebox that hadn’t seen a sweep in years. We replaced the duct run in smooth rigid pipe and set a stainless DuraFlex in Stanton cap on the flue, then verified draft with a Level 1 inspection before we called it done.
Chimney and Flue Cap Installation
Because Stanton’s dryer ducts and fireplace flues so often share a chase, we handle both termininations in the same call. If your flue cap is missing or rusted through, birds and rain are getting in. We install stainless caps sourced from Copperfield and Olympia Chimney, the same professional-trade hardware we use on chimney repairs throughout the region. It’s part of how we treat dryer vent work as a fire-safety service in one call.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Stanton
We stock ventilation components from Famco and flue caps and termininations from Copperfield so Stanton customers aren’t waiting on a parts order. These are the same materials professional contractors specify, not what you’d find on a hardware store shelf. When we replace a corroded vent hood or cap on a 1950s Stanton tract home, the part going on is built to handle coastal salt air for another few decades. That’s the standard. Dryer Vent Cleaning in Stanton customers should expect it.
See the difference
Before
After
Before
After
Before
AfterCommon Dryer Vent Cleaning Problems We See in Stanton Homes
- Salt-air corrosion on galvanised terminations. Original vent hoods and flue caps on 1950s – 60s tract homes rust through from years of coastal exposure. Once the cap fails, rain and birds move in, and the dryer vent flapper seizes shut behind it.
- Crushed foil flex duct at the wall chase. Builder-era vent hoods sit tight against the stucco, and the flex duct behind them kinks and crushes. Lint packs at the pinch point, airflow drops, and the dryer works longer and hotter than it should.
- Lint and creosote sharing the same chase. When the dryer vent termination exits near an uncapped masonry flue, warm lint-laden air drifts toward a flue already holding first- or second-degree creosote and old nesting. It’s a combination we see block after block off Beach Blvd and Western Ave.
- Years of neglect in rental units. Stanton has a significant share of older rental properties, and the dryer vent is often the last thing anyone thinks about until the dryer stops drying. By then the duct is usually packed solid and the termination is failing.
Pricing for Dryer Vent Cleaning in Stanton, CA
A standard dryer vent cleaning on a single-story Stanton tract home runs $129 – $189. Two-story homes add $30 – $50 for the longer duct run and ladder work. If the vent hood or cap needs replacement, stainless steel termininations run $85 – $150 installed depending on the roof or wall location. Rigid-pipe rerouting where flex duct has crushed runs $120 – $220, depending on the run length and access. If your dryer vent is paired with a chimney cap replacement in the same chase, we’ll combine the labor and the visit saves you money. Call (833) 805-3229 for a free estimate; we’ll give you a flat price before we book anything.
We Also Serve Cities Near Stanton
Our crews cover Stanton and the surrounding northwest Orange County area regularly, including Garden Grove, Cypress, Westminster, and Midway City. If you’re just outside 90680, the call still works. We schedule Stanton-area visits on the same route, so our response time to Stanton neighbors is measured in days, not weeks.
Serving Stanton, CA — Our Local Coverage Area
We’re based in the Stanton area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Stanton
Because your 1950s – 60s tract home was built with foil flex duct jammed behind a builder-grade galvalume vent hood, and both have been sitting in coastal salt air for six decades. The hood corrodes, the flapper seizes, the flex crushes at the bend, and the whole run chokes off. Newer homes use rigid pipe and stainless terminations from day one, so they don’t see the same buildup. We can fix that permanently. Call (833) 805-3229 for a free estimate.
Often yes, and that’s a Stanton-specific problem. The original masonry fireplace flue and the dryer duct share the same exterior wall chase in many of these tract layouts off Beach Blvd. That means a lint-clogged duct sits inches from a flue that was never capped and hasn’t been swept in years. When we clean the dryer vent, we check both. A duct fire next to an uncleaned flue is a risk you don’t want to test. Call (833) 805-3229 and we’ll inspect both in one visit.
Once a year, same as anywhere, but for a different reason. Stanton’s mild, dry climate means fireplaces get used sporadically, so creosote builds slowly. The bigger issue is the opposite: chimneys sit idle long enough for birds, squirrels, and debris to move in, and the dryer vent termination is usually right there in the same chase. Annual dryer vent cleaning catches the lint before it packs, and it gives us a reason to look at the chimney cap while we’re there. Call (833) 805-3229 to book a combined visit.
The galvanised cap or vent hood. Salt air off the coast eats through galvalume in a decade or two, and most Stanton tract homes are well past that point. The hood rusts through at the hinge, the flapper seizes shut, and rain and birds get in. Then the flex duct behind it crushes from the weight and the lint packs in. We replace them with stainless steel, and the problem stops recurring. Call (833) 805-3229 for an exact quote.
It can, and it’s one of the most common calls we get from Stanton homeowners. When the flapper seizes shut from salt-air corrosion, the dryer pushes moist, lint-laden air into a dead end. Lint backs up through the duct and can blow back into the laundry room, especially on two-story homes where the run is longer. The fix is a stainless hood with a clean, free-moving flapper, plus a full duct cleaning to clear what’s already packed in. Call (833) 805-3229 and we’ll sort it out.
Written by Norm Castillo, Owner at Ashwood Chimney Sweep, serving Stanton since the company’s founding.