Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Irvine, CA
Chimney repair in Irvine usually means working on factory-built metal flue systems in 1970s – 2000s tract housing, not centuries-old brick stacks. Most calls we get involve gas fireplaces that have sat dormant for seasons, bird-screened caps that are clogged, or liners inside factory-built systems that have begun to separate. If you’re noticing staining around your chase cover, a fireplace that won’t draw, or moisture inside the firebox, call (833) 805-3229 and Ashwood Chimney Sweep will assess the whole system.
Why Irvine Homes Are Different
Irvine is a master-planned city, and that shapes the work in ways you won’t see in older Southern California towns. Almost every chimney here belongs to a wood-burning or gas fireplace inside a planned village tract home: Woodbridge, Northwood, Westpark, Turtle Rock, or the newer high-density condo and apartment developments around the Spectrum and Great Park. These are factory-built metal flue systems, not masonry chimneys, which means lining, cap, and flashing work follows a different set of materials and methods than an old brick stack would.
The dry Mediterranean climate and fall Santa Ana wind events matter too. Fireplaces in Irvine sit unused most of the year because the South Coast Air Quality Management District restricts wood burning on many winter days. A chimney can go months without a fire, then get used hard on a few cold, legally burnable nights. That pattern lets bird nests, dried debris, and fine soot accumulate in the flue, and when a fire finally does run, the Santa Ana winds can make exterior sparks and embers a genuine concern. Our crews expect to find systems that need a thorough inspection before first use rather than a simple sweep.
Styles & brands we work with
Our Main Irvine Services
Two services account for most calls from Irvine homeowners. One is the annual chimney check and cleaning, the other is dryer vent work, which we treat as a fire-safety service with the same weight as a chimney inspection. Both begin with a phone call and an estimate.
Chimney Sweep in Irvine
The typical Irvine chimney sweep includes removing the cap screen, brushing the flue, cleaning the firebox and smoke shelf, and then a camera inspection of the interior. Because so many Irvine systems sit unused for long stretches, what looks like a simple cleaning often reveals nests, spider webs, or a damper that’s rusted in place. Once the system is clean, we check clearances to the chimney chase, the termination, and the condition of the cap. For a full breakdown of the sweep process in Irvine, see our Chimney Sweep in Irvine page.
Dryer Vent Cleaning in Irvine
Dryer vents in Irvine homes tend to be long interior runs through walls and up through attics in two-story tract layouts, which means lint builds up out of sight. A clogged dryer vent is a fire system issue, not a convenience problem. We clean the full run from dryer to exterior termination, inspect the duct and connections, and use Famco hardware when a damper or connector needs replacing. For detail on exactly what’s included in Irvine, visit our Dryer Vent Cleaning in Irvine page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Irvine
Most chimney repair work in Irvine involves the top of the system: caps, chase covers, flashings, and crowns on factory-built flues in homes from the 1980s through the 2000s. The dry air and Santa Ana winds work metal and sealant joints loose, and a home in Woodbridge or Northwood that has gone several seasons without a fire will often show rust or water intrusion by the time someone opens the damper again. Repair here means working with materials accepted by the professional chimney trade, including Chimney Repair done with products from Copperfield and DuraFlex, not aftermarket substitutes. We inspect the full flue path with a camera before recommending anything, and we will tell you plainly when a repair can safely wait.
Chimney Cap Installation
Signs you need it
You see daylight through the top of the flue from inside the firebox, or birds, leaves, and wasps keep getting into the system.
What it costs in Irvine
Chimney cap installation in Irvine typically costs between $350 and $750 depending on cap size and access to the chase top.
How we do it
We measure the flue termination, select a stainless or copper cap sized to the existing collar, and fasten it to withstand the Santa Ana gusts that hit exposed chase tops.
Chimney Cap Replacement
Signs you need it
The existing cap is rusted through, the mesh screen is missing, or the cap has pulled loose from the flue.
What it costs in Irvine
Replacing a damaged cap in Irvine generally runs between $400 and $800, with the final number depending on flue size and whether the chase top needs new mounting hardware.
How we do it
We remove the old cap, inspect the flue top for rust or water damage, and install a correctly sized replacement with stainless hardware.
Chimney Liner Installation
Signs you need it
A camera inspection shows gaps, separated sections, or pitting in the existing metal liner, or you smell exhaust odors inside the home.
What it costs in Irvine
A new liner installation in Irvine typically falls between $1,800 and $3,500 depending on flue length, diameter, and the condition of the chase.
How we do it
We assess the full flue path, pull a new DuraFlex flexible liner to the correct length, and connect and terminate it through the existing chase and cap assembly.
Chimney Flashing Repair
Signs you need it
You see water staining on the ceiling near the chimney chase or drips inside the firebox after rain.
What it costs in Irvine
Flashing repair around the chimney chase in Irvine normally costs between $400 and $900, with taller two-story chases pushing toward the upper end.
How we do it
We cut back the old sealant and flashing, inspect the joint where the chase meets the roofline, and reseal with professional-grade materials that hold through Irvine’s dry heat and seasonal rain.
What Chimney Repair Costs in Irvine
| Item | Typical range in Irvine |
|---|---|
| Chimney cap installation | $350 – $750 |
| Chimney cap replacement | $400 – $800 |
| Chimney flashing repair | $400 – $900 |
Labor in Irvine runs slightly higher than in the Inland Empire due to travel time and the two-story nature of most tract homes. You will always know the full price before we begin, not after we start finding problems.
How much does chimney repair cost in Irvine?
A simple cap replacement runs $400 to $800. A liner installation runs $1,800 to $3,500, and most repairs fall somewhere within that span. Call (833) 805-3229 for a flat-price estimate before any work is scheduled.
Do I need a new liner, or can you repair the existing one?
If the liner has separated or pitted past a certain point, yes. But when the damage is limited to cracks and spalling, HeatShield restoration can repair the flue without tearing out the old liner and pulling a new one through the chase. We will show you the camera footage either way and let you decide.
Brands We Service in Irvine
Our Irvine crews carry and install materials from Copperfield, DuraFlex, and Famco. These are professional-trade brands, not retail substitutes, so replacement parts in your home match what the system was originally designed to use. Most common cap and vent components are stocked in our service vehicles, which means no waiting on a second trip to a distributor for the work Irvine residents ask for most. Read more about our brands and what we keep on hand.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Irvine, CA
| Service | Typical range in Irvine |
|---|---|
| Chimney sweep (Level 1 inspection included) | $180 – $340 |
| Chimney cap installation | $350 – $750 |
| Chimney cap replacement | $400 – $800 |
| Chimney flashing repair | $400 – $900 |
| Chimney liner installation | $1,800 – $3,500 |
| Chimney crown repair | $600 – $1,200 |
| Dryer vent cleaning | $150 – $300 |
What pushes a price higher in Irvine is usually access: a second-story chase top on a steep roofline, a flue buried inside a tightly built chase, or a system that has gone so long without service that the first cleaning turns into disassembly. The one number that does not change is the one on your estimate. We give you a flat price before the work starts, not a starting rate that climbs.
Neighborhoods We Serve in Irvine
Our crews work throughout the city’s planned villages and condo communities, and most Irvine calls can be scheduled within a few business days, depending on the season and the scope of the job.
- Woodbridge
- Northwood
- Westpark
- Turtle Rock
- Great Park
Service Area – Cities Near Irvine
Ashwood Chimney Sweep also serves the communities around Irvine. Homeowners in Tustin, CA, Aliso Viejo, CA, Santa Ana, CA, and North Tustin, CA call us for the same chimney, dryer vent, and repair work described on this page. If you’re in one of these nearby cities and your system needs attention, the scope of work is identical.
Serving Irvine, CA — Our Local Coverage Area
We’re based in the Irvine area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Irvine
In most Irvine villages, exterior work like a visible cap or chase cover change may require architectural committee approval, especially in villages with strict exterior standards like Woodbridge or Westpark. Interior work, like a liner repair or sweep, usually does not. We can tell you what’s visible and what’s not before you file anything.
Most routine sweeps and inspections in Irvine can be scheduled within a few business days. Fall is the busiest season because South Coast AQMD burn rules push everyone to the same few weeks. If you want the system inspected before the first legal burn night, call (833) 805-3229 in late summer or early fall, not November.
Yes. A large share of our Irvine work is gas fireplace service: checking the log set, the vent path, and the condition of the factory-built flue and termination. Gas systems still need annual inspection because the vent can corrode or clog even when no wood ever burns. Call us for an estimate on either type.
If your chimney, fireplace, or dryer vent needs a proper look from a company that works with professional-grade materials throughout Irvine, call Ashwood Chimney Sweep at (833) 805-3229. Estimates are free, and we’ll tell you straight if the work can wait.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Irvine Customers Say
"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
— Angela Kim"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
— Yolanda Martinez"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Paige Norris